DragonWave Inc. 24
Horizon Compact Release 1.01.00 Wireless Ethernet Product User Manual – Volume 2
Required Action Steps
set radius super user
authentication
This commands enables or disables the Super user from accessing a
modem, when the RADIUS server does not respond, or is not
available. If set to “off” the Super user is allowed to log in using the
name and password set in the modem. The default setting is “off”.
Sequence:
set radius super user authentication strict [on/off] press Enter
The system responds:
Radius authentication for Super User is now [strict/not strict]
A save mib command will make this command effective immediately.
WARNING: If super user authentication is set to ON, and the Super
user name and password are not entered into the RADIUS system, the
Super user will not be able to regain access to the modem after a
reset.
get radius super user
authentication strict
This command returns the status of the radius super user.
Sequence:
get radius super user authentication strict press Enter
The system responds:
Radius authentication for Super User is [strict/not strict]
(not strict means SU flash password still works under Radius)
save mib
Saves the MIB to RAM. Perform this command to save setting
changes to non-volatile memory.
Sequence:
save mib press Enter
The system responds:
MIB saved successfully.
Reset system
A system reset is required to activate this feature.
Sequence
reset system press Enter
The system responds:
Are you sure you want to reset? Y(yes) or N(no)
press Y
The system will proceed to reset. You will have to log on again to
regain access.
To Next Page
Loading...