Advanced Configuration Features
29
Horizon Compact Release 1.01.00 Wireless Ethernet Product User Manual – Volume 2
Procedure 3-2
Enable VLAN tagging
Perform this procedure to enable VLAN tagging for the Horizon Compact.
Note: To perform this procedure, you must have NOC user rights.
Required Action Steps
login Log in as a NOC user.
get vlan tagging Displays the VLAN tagging operational state for the system.
Sequence:
get vlan tagging press Enter
The system responds:
VLAN tagging: [off | on]
set vlan tagging [on|off] Sets the VLAN tagging operational state for the system.
Sequence:
set vlan tagging [off | on ] press Enter
The system responds:
VLAN tagging: [off |on]
set vlan tag [XXXX] Enables or disables the VLAN tagging operational state you set when
you executed the set vlan tagging command. VLAN tagging follows the
802.1Q standard.
Note: If you set the VLAN tag to the incorrect value, you can lose
remote access to the Horizon Compact. Make sure the VLAN tag
matches your administrative network tag.
Sequence:
set vlan tag [XXXX] [Y]press Enter
where
[XXXX] is the two–byte tag control
[Y] is the priority bit for 802.1P and is in the range of 0-7.
The system responds:
VLAN tag: [XXXX Y]
To Next Page
Loading...