DragonWave Inc. 30
Horizon Compact Release 1.01.00 Wireless Ethernet Product User Manual – Volume 2
Required Action Steps
get vlan tag Displays that the VLAN tagging information for the system. VLAN
tagging is enabled when a valid VLAN tag has been entered using the
set vlan tag command. Note: If you have entered an incorrect VLAN
tag, you cannot communicate remotely with the Horizon Compact.
Sequence:
get vlan tag press Enter
The system responds:
VLAN ID :[ XXXX]
VLAN Priority is [Y]
save mib
Saves the MIB to RAM. Perform this command to save setting
changes to non-volatile memory.
Sequence:
save mib press Enter
The system responds:
MIB saved successfully.
Reset system
A system reset is required to activate this feature.
Sequence
reset system press Enter
The system responds:
Are you sure you want to reset? Y(yes) or N(no)
press Y
The system will proceed to reset. You will have to log on again to
regain access.
This concludes the steps to enable VLAN tagging for the Horizon Compact system using the CLI
manager.
To Next Page
Loading...