Advanced Configuration Features
37
Horizon Compact Release 1.01.00 Wireless Ethernet Product User Manual – Volume 2
Procedure 3-3
Enable 802.1P Priority Queuing
Perform this procedure to enable 802.1P Priority Queuing for the Horizon Compact.
Note: To perform this procedure, you must have NOC user rights.
Required Action Steps
login Log in as a NOC user.
set qos [on/off]
Enables or disables (on or off) quality of service (QoS) on the Horizon
Compact system. QoS is part of the 802.1P specification.
Sequence:
set qos [on/off] press Enter
where on will enable QoS and off will disable QoS
The system responds:
qos is : [on/off]
set cos type
Sets the CoS system to handle VLAN or Q-in-Q frame formats.
Sequence:
set cos type
[cos_vlan/cos_qinq_itag/cos_qinq_otag/cos_dscp] press Enter
The system responds:
CoS type is set to :
cos_vlan/cos_qinq_itag/cos_qinq_otag/cos_dscp
Note: cos_vlan uses the priority tag of standard VLAN frames
cos_qinq_itag uses the inner priority tag of a Q-in-Q frame
cos_qinq_otag uses the outer priority tag of a Q-in-Q frame
cos_dscp uses the 3 bit priority information in the DSCP field
of the IP header (also referred to as ToS).
To Next Page
Loading...