DragonWave Horizon COMPACT - Page 61

Advanced Configuration Features
61
Horizon Compact Release 1.01.00 Wireless Ethernet Product User Manual – Volume 2
Procedure 3-12
Verify Authentication status
Use this procedure to verify the authentication action for the system.
Note: To perform this procedure, you must be logged into the system as an NOC user.
Required Action Steps
login Log in using a NOC account.
Get authentication status Displays the authentication status between two corresponding Horizon
Compact systems.
Sequence:
get authentication status press Enter
Where
[authentication Status] is one of the following:
Authenticated
NotAuthenticated
ExplicitAuthenticationFailure
The system responds:
Authentication status:
[AuthenticatedNotAuthenticatedExplicitAuthenticationFailure]
Explanations:
If authentication has failed:
check the setting for action on authentication failure; and
ensure it is not set to Block Traffic (unless that is the intended action).
If authentication has not failed:
check to see if traffic is now flowing.
If traffic is flowing then the authentication has been re-established and
the system is operating normally
If traffic is not flowing, the problem is not due to authentication.
set authentication failure
[block_traffic/pass_traffic]
Configures the action to take on peer authentication failure.
Sequence:
set authentication failure [block_traffic/pass_traffic] press Enter
The system responds:
System will [block_traffic/pass_traffic] on peer authentication failure.
.