Advanced Configuration Features
75
Horizon Compact Release 1.01.00 Wireless Ethernet Product User Manual – Volume 2
Required Action Steps
set rls signal degrade
parameters [up err rate] [dn
err rate] [up time] [dn time]
The RLS signal degrade parameters are used in both Basic and
Advanced RLS modes. The parameters supplied determine the
conditions under which RLS will disable and re-enable the Horizon
Compact data Ethernet port (Port 1).
Sequence:
set rls signal degrade parameters [up err rate] [dn err rate] [up
time] [dn time] press Enter
Where
[up err rate] is the target block error rate required to re-enable the
data Ethernet port. The current block error rate must be equal to or
better than this value. The target rate is expressed in Scientific
Notation.
[dn err rate] is the target block error rate required to activate RLS and
disable the data Ethernet port. The current block error rate must be
equal to or worse than this value. The target rate is expressed in
Scientific Notation.
[up time] is the time, in milliseconds, to sample the data stream to
determine if the [up err rate] condition has been met. Note that the
system will round this value up to the nearest multiple of the minimum
sample time required to detect the [up err rate].
[dn time] is the time, in milliseconds, to sample the data stream to
determine if the [dn err rate] condition has been met. Note that the
system will round this value up to the nearest multiple of the minimum
sample time required to detect the [dn err rate].
The default settings are 9.00E-07 1.00E-05 120000 20000
The system responds:
RLS Degrade Monitor Parameters: 9.00E-07 1.00E-05 120000 20000
To Next Page
Loading...