DragonWave Inc. 78
Horizon Compact Release 1.01.00 Wireless Ethernet Product User Manual – Volume 2
Required Action Steps
set rls signal fault parameters
[fault period msec] [fault
threshold]
Sets the RLS signal fault monitor parameters. The RLS signal fault
settings are designed to detect and react to brief bursts of extreme
modem block error rates. The RLS signal fault detection and reaction
time is the quickest of the two RLS fault detection methods. RLS
signal fault detection works with the RLS signal degrade settings in
Advanced mode.
Sequence:
set rls signal fault parameters [fault period msec] [fault threshold]
press Enter
Where
[fault sample period msec] is the sample period to apply Fault
Threshold ratio
[fault threshold percentage] is the ratio of 'fault sample period'
faulted before the link is shut down.
The system responds:
RLS Signal Fault Parameters: 1000 100
save mib Saves the MIB to RAM. Perform this command save setting changes
to FLASH. This command does not restart the system and does not
put any new settings into effect. A system reset command will cause
settings in RAM to be programmed into FLASH and to take effect.
Sequence:
save mib press Enter
The system responds:
MIB saved successfully.
reset system Resets the system to save the settings to FLASH and restart the
system with the new settings taking effect.
Sequence:
reset system press Enter
The system responds:
Are you sure you want to reset? Y(yes) or N(no)
press Y
Once the system reboots, login and continue with the RLS
configuration.
This concludes the steps to configure Rapid Link Shutdown for the Horizon Compact system using the
CLI manager.
To Next Page
Loading...