Vigor2862 Series User’s Guide
135
2. Configure the channel as follows,
(a) enable this channel
(b) set WAN Type to the WAN interface that the service provider is on.
(c) enter the VLAN Tag and Priority as the service provider requires.
(d) enable "Open WAN Interface for this Channel", and select the kind of Application
will be used on this channel. (Note: this option is only available on channel 5-7)
(e) set up the Internet Access type as the ISP requires.
3. Click OK to save the profile and reboot the router to apply the settings. After the router
restart, go to Online Status >> Virtual WAN to make sure the WAN interface is up and
has obtained an IP address.
To Next Page
Loading...
Need help?
General
