Vigor2862 Series User’s Guide
68
throughput might be reached; however, some web site may
not open smoothly, especially the site need authentication,
e.g., FTP.
If you have no strong demand about speed test result, keep
default settings as IP based.
Index Click the WAN interface link under Index to access into the
WAN configuration page.
Enable V means such WAN interface is enabled and ready to be used.
Physical Mode / Type Display the physical mode and physical type of such WAN
interface.
Line Speed(Kbps)
DownLink/UpLink
Display the downstream and upstream rate of such WAN
interface.
Active Mode Display whether such WAN interface is Active device or
backup device.
Backup (WAN#) - Display the backup WAN interface for such
WAN when it is disabled.
Load Balance V means the function of load balance for such WAN interface
is enabled.
Info
In default, each WAN port is enabled.
After finished the above settings, click OK to save the settings.
I
I
I
I
-
-
1
1
-
-
1
1
-
-
1
1
W
W
A
A
N
N
1
1
(
(
A
A
D
D
S
S
L
L
/
/
V
V
D
D
S
S
L
L
2
2
)
)
Vigor router will detect the physical line is connected by ADSL or VDSL2 automatically.
Therefore, this page allows you to configure settings for ADSL and VDSL2 at one time. That is,
it is not necessary for you to configure different profile settings for ADSL and VDSL2
respectively.
To Next Page
Loading...
Need help?
General
