Draytek Vigor2862 Series - Hardware Acceleration; II-3-1 Setup

Vigor2862 Series User’s Guide
171
I
I
I
I
-
-
3
3
H
H
a
a
r
r
d
d
w
w
a
a
r
r
e
e
A
A
c
c
c
c
e
e
l
l
e
e
r
r
a
a
t
t
i
i
o
o
n
n
Hardware Acceleration is also called PPA in DrayTek for it is based on Protocol Processing
Engine (PPE) of Infineon. It can only support 128 sessions for network traffic (IN & OUT) with
implementing three kinds of modes - Disable, Auto and Manual.
Info Such feature is only supported by certain firmware version.
I
I
I
I
-
-
3
3
-
-
1
1
S
S
e
e
t
t
u
u
p
p
When the data traffic is heavy and data transmission is getting slowly and slowly, you can
configure this page to accelerate the data streaming by hardware itself. Open Hardware
Acceleration to access into the following page:
Available settings are explained as follows:
Item Description
Mode Disable – The default setting.
Auto - When the hardware acceleration is configured with
the Auto mode, the sessions with the heaviest loading and
the lower latency traffic will be added into PPA. However,