Vigor2862 Series User’s Guide
253
I
I
I
I
-
-
6
6
-
-
2
2
L
L
o
o
a
a
d
d
-
-
B
B
a
a
l
l
a
a
n
n
c
c
e
e
/
/
R
R
o
o
u
u
t
t
e
e
P
P
o
o
l
l
i
i
c
c
y
y
It allows network administrator to manage the outbound traffic more specifically. The policy
set in Load-Balance/Route Policy always has higher priority than Default Route and Auto
Load Balance set in WAN >> Internet Access, and always has lower priority than the Firewall
Rules. Administrator may also define a priority to this policy.
This page lists all the policies and shows whether the policy is enabled/disabled, what are the
criteria to match, and through which the interface should the traffic to go if the criteria are
matched, and also its priority.
Available settings are explained as follows:
Item Description
Index Click the number of index to access into the configuration
web page.
Enable Check this box to enable this policy.
Protocol Display the protocol used for this policy.
Interface Display the interface to send packets to once the policy is
matched.
Priority Display the priority value for such route policy profile.
Src IP Start Display the IP address for the start of the source IP.
Src IP End Display the IP address for the end of the source IP.
Dest IP Start Display the IP address for the start of the destination IP.
Dest IP End Display the IP address for the end of the destination IP.
Dest Port Start Display the IP address for the start of the destination port.
Dest Port End Display the IP address for the end of the destination port.
Move UP/Move Down Use Up or Down link to move the order of the policy.
Wizard Mode Allow to configure frequently used (simple and basic)
settings of route policy via three setting pages.
To Next Page
Loading...
Need help?
General
