Vigor2862 Series User’s Guide
154
I
I
I
I
-
-
2
2
-
-
1
1
-
-
3
3
D
D
e
e
t
t
a
a
i
i
l
l
s
s
P
P
a
a
g
g
e
e
f
f
o
o
r
r
I
I
P
P
R
R
o
o
u
u
t
t
e
e
d
d
S
S
u
u
b
b
n
n
e
e
t
t
Available settings are explained as follows:
Item Description
Network Configuration Enable/Disable - Click Enable to enable such configuration;
click Disable to disable such configuration.
For Routing Usage,
IP Address - This is the IP address of the router. (Default:
192.168.1.1).
Subnet Mask - The subnet mask, together with the IP Address
field, indicates the maximum number of clients allowed on
the subnet. (Default: 255.255.255.0/ 24).
RIP Protocol Control,
Enable – When Enabled, the router will attempt to exchange
routing information with neighbouring routers using the
Routing Information Protocol.
DHCP Server
Configuration
DHCP stands for Dynamic Host Configuration Protocol. The
router by factory default acts a DHCP server for your network
so it automatically dispatch related IP settings to any local
user configured as a DHCP client. It is highly recommended
that you leave the router enabled as a DHCP server if you do
not have a DHCP server for your network.
Start IP Address - Enter a value of the IP address pool for the
DHCP server to start with when issuing IP addresses. If the
1st IP address of your router is 192.168.1.1, the starting IP
address must be 192.168.1.2 or greater, but smaller than
192.168.1.254.
IP Pool Counts - Enter the maximum number of PCs that you
want the DHCP server to assign IP addresses to. The default is
50 and the maximum is 253.
Lease Time - Enter the time to determine how long the IP
address assigned by DHCP server can be used.
To Next Page
Loading...
Need help?
General
