Draytek Vigor2862 Series User Manual

Vigor2862 Series User’s Guide
7
I
I
-
-
1
1
-
-
1
1
-
-
3
3
V
V
i
i
g
g
o
o
r
r
2
2
8
8
6
6
2
2
V
V
a
a
c
c
LED Status Explanation
Off The router is powered off. ACT (Activity)
Blinking The router is powered on and running normally.
On USB device is connected and ready for use.
Off No USB device is connected.
USB
Blinking The data is transmitting.
On Internet connection is ready.
Off Internet connection is not ready.
WAN2
Blinking The data is transmitting.
On The router is ready to access Internet through DSL link. DSL
Blinking Slowly: The DSL connection is ready.
Quickly: The connection is training.
On 2.4G/5G: Wireless access point with bandwidth of
2.4GHz/5GHz is ready.
WLAN: Wireless access point is ready.
2.4G/5G
Blinking It will blink slowly while wireless traffic goes through.
ACT and WLAN LEDs blink quickly and simultaneously
when WPS is working, and will return to normal
condition after two minutes. (You need to setup WPS
within 2 minutes.)
On A PSTN phone call comes (in and out). However, when
the phone call is disconnected, the LED will be off.
Line
Off There is no PSTN phone call.
On The phone connected to this port is off-hook.
Off The phone connected to this port is on-hook.
Phone 1/2
Blinking A phone call comes.
LED on Connector
On The port is connected.
Off The port is disconnected.
Left
LED
Blinking The data is transmitting.
On The port is connected with 1000Mbps.
LAN
P1~P4
Right
LED
Off The port is connected with 10/100Mbps
On The port is connected.
Off The port is disconnected.
Left
LED
Blinking The data is transmitting.
On The port is connected with 1000Mbps.
P5 /
WAN2
Right
LED
Off The port is connected with 10/100Mbps

Draytek Vigor2862 Series Specifications

General

Brand	Draytek
Model	Vigor2862 Series
Category	Firewall
Language	English