Vigor2862 Series User’s Guide
6
Switch on Rear Side (Available for Vigor2862Ln/Lac)
Interface Description
Wireless LAN
ON/OFF/WPS
For Vigor2862n/Vigor2862Bn :
Press the button and release it within 2 seconds. When the
wireless function is ready, the green LED will be on.
Press the button and release it within 2 seconds to turn off the
WLAN function. When the wireless function is not ready, the
LED will be off.
For Vigor2862ac/Vigor2862Ln/Vigor2862Lac::
Wireless band will be switched /changed according to the button
pressed and released. For example,
2.4G (On) and 5G (On) – in default.
2.4G (Off) and 5G (On) – pressed and released the button once.
2.4G (On) and 5G (Off) – pressed and released the button
twice.
2.4G (Off) and 5G (Off) – pressed and released the button three
times.
When WPS function is enabled by web user interface, press this
button for more than 2 seconds to wait for client’s device making
network connection through WPS.
Factory Reset Restore the default settings. Usage: Turn on the router (ACT LED
is blinking). Press the hole and keep for more than 5 seconds.
When you see the ACT LED begins to blink rapidly than usual,
release the button. Then the router will restart with the factory
default configuration.
USB 1~2 Connecter for a USB device (for 3G/4G USB Modem or printer or
thermometer).
DSL / DSL 1/2 Connecter for accessing the Internet.
LAN P1~P4 Connecters for local network devices.
P5 / WAN2 Connecter for local network devices or modem for accessing
Internet.
PWR Connecter for a power adapter.
ON/OFF Power Switch.