EasyManuals Logo

Draytek Vigor2862 Series User Manual

Draytek Vigor2862 Series
988 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #173 background imageLoading...
Page #173 background image
Vigor2862 Series User’s Guide
15
7
configuration Prefix Length – Type the fixed value for prefix length.
Add – Click it to add a new entry.
Delete – Click it to remove an existed entry.
Unique Local Address
(ULA) configuration
Unique Local Addresses (ULAs) are private IPv6 addresses
assigned to LAN clients.
Off - ULA is disabled.
Manually ULA Prefix - LAN clients will be assigned ULAs
generated based on the prefix manually entered.
Auto ULA Prefix - LAN clients will be assigned ULAs using an
automatically-determined prefix.
Current IPv6 Address
Table
Display current used IPv6 addresses.
DNS Server IPv6 Address Deploy when WAN is up – The RA (router advertisement)
packets will be sent to LAN PC with DNS server information
only when network connection by any one of WAN interfaces
is up.
Enable – The RA (router advertisement) packets will be sent
to LAN PC with DNS server information no matter WAN
connection is up or not.
Primary DNS Sever – Type the IPv6 address for Primary
DNS server.
Secondary DNS Server –Type another IPv6 address for
DNS server if required.
Disable – DNS server will not be used.
Management Configures the Managed Address Configuration flag (M-bit) in
Route Advertisements.
Off - No configuration information is sent using Route
Advertisements.
SLAAC(stateless) - M-bit is unset.
DHCPv6(stateful) - M-bit is set, which indicates to LAN
clients that they should acquire all IPv6 configuration
information from a DHCPv6 server. The DHCPv6 server
can either be the one built into the Vigor2860, or a
separate DHCPv6 server.
Other Option (O-bit) - Check this box to enable the O-bit for
obtaining additional information (e.g., DNS) from DHCPv6.
DHCPv6 Server Enable Server –Click it to enable DHCPv6 server. DHCPv6
Server could assign IPv6 address to PC according to the
Start/End IPv6 address configuration.
Disable Server –Click it to disable DHCPv6 server.
Auto IPv6 range – After check the box, Vigor router will
assign the IPv6 range automatically.
Start IPv6 Address / End IPv6 Address –Type the start and

Table of Contents

Other manuals for Draytek Vigor2862 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Draytek Vigor2862 Series and is the answer not in the manual?

Draytek Vigor2862 Series Specifications

General IconGeneral
BrandDraytek
ModelVigor2862 Series
CategoryFirewall
LanguageEnglish

Related product manuals