Vigor2862 Series User’s Guide
293
Next Click it to get into the next setting page.
Cancel Exit the wireless wizard without saving any changes.
3. After typing the required information, click Next. The settings in the page limit the
wireless station (guest) accessing into Internet but not being allowed to share the LAN
network and VPN connection.
Available settings are explained as follows:
Item Description
Wireless 2.4GHz Settings
Enable/Disable Click it to enable or disable settings in this page.
SSID Type the SSID name of this router. (SSID1)
Security Key The wireless mode offered by this wizard is WPA2/PSK.
The WPA encrypts each frame transmitted from the radio
using the key, which either PSK (Pre-Shared Key) entered
manually in this field below or automatically negotiated via
802.1x authentication.
Either 8~63 ASCII characters, such as 012345678(or 64
Hexadecimal digits leading by 0x, such as
"0x321253abcde...").
Bandwidth Limit Enable – Check the box to set the bandwidth limit for data
transmission in upload and download.
It controls the data transmission rate through wireless
connection.
Total Upload – Check Enable and type the transmitting rate
for data upload. Default value is 30,000 kbps.
Total Download – Type the transmitting rate for data
download. Default value is 30,000 kbps.
Wireless 5GHz Settings
Enable/Disable Click it to enable or disable settings in this page.
Use the same SSID
and Security Key as
Check the box to use the same settings configured above.
To Next Page
Loading...
Need help?
General
