Vigor2862 Series User’s Guide
300
Available settings are explained as follows:
Item Description
Enable Mac Address Filter
Select to enable the MAC Address filter for wireless LAN
identified with SSID 1 to 4 respectively. All the clients
(expressed by MAC addresses) listed in the box can be
grouped under different wireless LAN. For example, they can
be grouped under SSID 1 and SSID 2 at the same time if you
check SSID 1 and SSID 2.
MAC Address Filter Display all MAC addresses that are edited before.
Client’s MAC Address Manually enter the MAC address of wireless client.
Apply SSID After entering the client’s MAC address, check the box of the
SSIDs desired to insert this MAC address into their access
control list.
Attribute s: Isolate the station from LAN - select to isolate the
wireless connection of the wireless client of the MAC address
from LAN.
Comment Type a brief description for the specified client’s MAC
address.
Add Add a new MAC address into the list.
Delete Delete the selected MAC address in the list.
Edit Edit the selected MAC address in the list.
Cancel Give up the access control set up.
OK Click it to save the access control list.
Clear All Clean all entries in the MAC address list.
Backup Access Control Settings on this web page can be saved as a file which can be
restored in the future by this device or other device.
Upload From File Restore wireless access control settings and applied onto this
device.
After finishing all the settings here, please click OK to save the configuration.
To Next Page
Loading...
Need help?
General
