Vigor2862 Series User’s Guide
506
button.
Disabling the Factory Reset button only prevents it from
being used to reboot Vigor router with default settings. It
can still be used to wake up the LEDs when LED sleep mode is
enabled.
Enable Wireless Button The default value is Enabled.
Deselect to disable the ability of the Wireless button to
control WLAN and WPS functions.
Disabling the wireless button only prevents it from being
used to control WLAN functions. It can still be used to wake
up the LEDs when LED sleep mode is enabled.
After finished the above settings, click OK to save the configuration.
F
F
o
o
r
r
U
U
S
S
B
B
The USB ports can be individually enabled or disabled. When a USB port is disabled, attached
devices will not be recognized by the router.
Available settings are explained as follows:
Item Description
Refresh Click to refresh the page to display the latest information.
Port The number corresponds to the USB port number shown on
the front panel.
Enable Deselect to disable the USB port. The default value is
enabled.
Status Shows the status of the USB port.
No device – no USB device is connected to the port.
Connected – a USB device is connected to the port.
--- – the USB port is disabled.
After finished the above settings, click OK to save the configuration.
F
F
o
o
r
r
L
L
A
A
N
N
P
P
o
o
r
r
t
t
The 4 LAN ports can be individually enabled or disabled. When a LAN port is disabled,
attached devices will not be recognized by the router.
To Next Page
Loading...
Need help?
General
