VigorAP 800 User’s Guide
7
1
1
.
.
3
3
.
.
3
3
P
P
O
O
E
E
C
C
o
o
n
n
n
n
e
e
c
c
t
t
i
i
o
o
n
n
VigorAP 800 can gain the power from the connected switch, e.g., VigorSwitch P2260. PoE
(Power over Ethernet) can break the install limitation caused by the fixed power supply.
1. Connect VigorAP 800 to a switch in your network through the LAN A1 port of the
access point by Ethernet cable.
2. Connect a computer to LAN A2 – A4. Make sure the subnet IP address of the PC is the
same as VigorAP 800 management IP, e.g., 192.168.1.X.
3. Power on VigorAP 800.
4. Check all LEDs on the front panel. ACT LED should be steadily on, LAN LEDs
should be on if the access point is correctly connected to the ADSL modem, router or
switch/hub.
To Next Page
Loading...
