VigorAP 800 User’s Guide
14
2
2
.
.
5
5
A
A
c
c
c
c
e
e
s
s
s
s
i
i
n
n
g
g
t
t
o
o
W
W
e
e
b
b
U
U
s
s
e
e
r
r
I
I
n
n
t
t
e
e
r
r
f
f
a
a
c
c
e
e
All functions and settings of this access point must be configured via web user interface.
Please start your web browser (e.g., IE).
1. Make sure your PC connects to the VigorAP 800 correctly.
Notice: You may either simply set up your computer to get IP dynamically
from the modem or set up the IP address of the computer to be the same subnet
as the default IP address of VigorAP 800 192.168.1.1. For the detailed
information, please refer to the later section - Trouble Shooting of the guide.
2. Open a web browser on your PC and type http://192.168.1.2. A pop-up window will
open to ask for username and password. Pease type “admin/admin” on
Username/Password and click OK.
3. The Main Screen will pop up.
Note:
If you fail to access to the web configuration, please go to “Trouble
Shooting” for detecting and solving your problem. For using the device properly, it
is necessary for you to change the password of web configuration for security and
adjust primary basic settings.
To Next Page
Loading...
Need help?
General
