VigorAP 800 User’s Guide
44
transfer performance.
WEP Key Entry
Method
There are two types of key method: ASCII and Hex. When you
select a key format, the number of characters of key will be
displayed. For example, if you select 64-bit as key length, and
Hex as key format, you’ll see the message at the right of Key
Format is ‘Hex (10 characters) which means the length of WEP
key is 10 characters.
WEP Keys (Key 1 – Key
4)
Input WEP key characters here, the number of characters must
be the same as the number displayed at Key Format field. You
can use any alphanumerical characters (0-9, a-z, and A-Z) if you
select ASCII key format, and if you select Hex as key format,
you can use characters 0-9, a-f, and A-F. You must enter at least
one encryption key here. If you entered multiple WEP keys,
they should not be the same with each other.
Default Key
You can set up to four sets of WEP key, and you can decide
which key is being used as default here. If you don’t know
which one you should use, select ‘Key 1’.
Below shows an example for a wireless profile created.
To Next Page
Loading...
Need help?
General
