To Next Page

To Previous Page

VigorAP 902 User’s Guide

Available settings are explained as follows:

Item Description

LAN-A IP Network

Configuration

Enable DHCP Client – When it is enabled, VigorAP 902 will

be treated as a client and can be managed / controlled by AP

Management server offered by Vigor router (e.g., Vigor2860).

IP Address – Type in private IP address for connecting to a local

private network (Default: 192.168.1.2).

Subnet Mask – Type in an address code that determines the size

of the network. (Default: 255.255.255.0/ 24)

Default Gateway – In general, it is not really necessary to

specify a gateway for VigorAP 902. However, if it is required,

simply type an IP address as the gateway for VigorAP 902. It

will be convenient for the access point to acquire more service

(e.g., accessing NTP server) from Vigor router.

Enable Management VLAN – VigorAP 902 supports tag-based

VLAN for wireless clients accessing Vigor device. Only the

clients with the specified VLAN ID can access into VigorAP

902.

VLAN ID – Type the number as VLAN ID tagged on the

transmitted packet. “0” means no VALN tag.

LAN-B IP Network