VigorAP 902 User’s Guide
76
3
3
.
.
6
6
.
.
3
3
S
S
t
t
a
a
t
t
i
i
s
s
t
t
i
i
c
c
s
s
This page displays the statistics for data transmission and receiving between the access point
and the stations.
Click Reset Counters if required.
3
3
.
.
6
6
.
.
4
4
W
W
P
P
S
S
(
(
W
W
i
i
-
-
F
F
i
i
P
P
r
r
o
o
t
t
e
e
c
c
t
t
e
e
d
d
S
S
e
e
t
t
u
u
p
p
)
)
Wi-Fi Protected Setup (WPS) is the simplest way to build connection between wireless
network clients and the access point. You don’t have to select encryption mode and input a
long encryption passphrase every time when you need to setup a wireless client. You only
have to press a button on wireless client and the access point, and the WPS will do the setup
for you.
VigorAP 902 supports two types of WPS: Push-Button Configuration (PBC), and PIN code.
If you want to use PBC, you have to switch VigorAP 902 to WPS mode and push a specific
button on the wireless client to start WPS mode. You can push Reset/WPS button of this
VigorAP 902, or click PBC Start button in the web configuration interface to do this; if you
want to use PIN code, you have to provide the PIN code of the wireless client you wish to
connect to this access point and then switch the wireless client to WPS mode.
Note: WPS function of VigorAP 902 will not work for those wireless AP/clients do not
support WPS.
To use WPS function to set encrypted connection between VigorAP 902 and WPS-enabled
wireless AP, please open Wireless LAN >>WPS. The following information will be
displayed:
To Next Page
Loading...
Need help?
General
