VigorAP 902 User’s Guide
53
3
3
.
.
5
5
.
.
6
6
A
A
P
P
D
D
i
i
s
s
c
c
o
o
v
v
e
e
r
r
y
y
VigorAP 902 can scan all regulatory channels and find working APs in the neighborhood.
Based on the scanning result, users will know which channel is clean for usage. Also, it can
be used to facilitate finding an AP for a WDS link. Notice that during the scanning process
(about 5 seconds), no client is allowed to connect to Vigor.
This page is used to scan the existence of the APs on the wireless LAN. Please click Scan to
discover all the connected APs.
Each item is explained as follows:
Item Description
Enable AP Monitor
Mode
This function can help to get and keep the records of APs
detected by such device after clicking Scan.
In general, only the available AP will be detected by Vigor
device. Once the AP is unavailable, it will be deleted from the
Access Point List immediately. However, if such function is
enabled, the system will keep the record of the AP (once
detected by Vigor device) until it is available for Vigor device
again.
SSID
Display the SSID of the AP scanned by VigorAP 902.
BSSID
Display the MAC address of the AP scanned by VigorAP 902.
RSSI
Display the signal strength of the access point. RSSI is the
abbreviation of Received Signal Strength Indication.
Channel
Display the wireless channel used for the AP that is scanned by
VigorAP 902.
Encryption
Display the encryption mode for the scanned AP.
Authentication
Display the authentication type that the scanned AP applied.
Mode
Display the wireless connection mode that the scanned AP
To Next Page
Loading...
Need help?
General
