MANUAL PC-200
Ver. 2.12.xx/10/22/2010-UK
Page 26 (61)
T i m e / D e l a y s . ►
◄
0
5.3 Pump settings
In the pump settings menu, all settings are made that directly deal with the pumps, start /stop levels,
alternation of the pumps, current settings a.s.o. These settings are made for each pump that is used, but
here only the settings for one pump (pump 1) are shown.
S t a r t l e v e l P 1
◄◄ 3 . 5 0
S t o p l e v e l P 1
◄◄ 0 . 5 0
A l t e r n a t i o n P 1
◄◄ Ja
M a x r u n t i m e 1 [ m i n ]
◄◄ 7 2 0
M i n b r e a k t i m e 1 [ s ]
◄◄ 1
R u n n i n g c o n f . ►
◄◄
C o n f . t i m e [ s ]
◄◄◄ 1 0
F u n c t i o n
◄◄◄ i n u s e
C u r r e n t s e t . ►
◄◄
B l o c k P u m p
◄◄◄ N o
S t a r t t i m e P 1 [ s ]
◄◄◄
U n d e r c u r r e n t ►
◄◄◄
1 - m i n [ A ]
◄◄◄◄ 0 . 0
A l a r m f u n c t i o n
◄◄◄◄ No
O v e r c u r r e n t
◄◄◄
1 - m a x [ A ]
◄◄◄◄ 0 . 0
A l a r m f u n c t i o n
◄◄◄◄ No
Settings for P2 and P3 are
made the same as for P1.
Following choices, Yes and No
Here the max running time
Is set in minutes
Here the break time before a
pump is allowed to startr is set
Here the time is set before
the answer is checked
Following choices, in use and
not in use
Following choices, in use and
not in use
Pump running time before
measuring starts
More in I/O settings
and Current settings
Setting of lowest current
before alarm
Timedelay before alarm is
sent
Setting of highest current
before alarm.
sent
Pump running time before
measuring starts
Following choises,Yes or No
Timedelay before alarm is
sent
Following choises,Yes or No
To Next Page
Loading...
