Drip Drop PC-200 - Level settings; Start and stop levels; Manual start and stop of pumps; Manual Control

MANUAL PC-200
Ver. 2.12.xx/10/22/2010-UK
Page 41 (61)
P 1 n o c o m m a n d
a v a i l a b l e
S t a r t P 2
S t o p P 3
a r t P 3
S t a r t l e v e l P 1
3 . 0 0
S t o p l e v e l P 1
◄ 0 . 5 0
0
S t a r t l e v e l P 2
◄ 3 . 5 0
S t o p l e v e l P 2
◄ 0 . 6 0
0
S t a r t l e v e l P 3
◄ 5 . 6 0
0
S t o p l e v e l P 3
◄ 0 . 5 0
0
L o w l e v e l [ m ]
◄ 0 . 4 0
0
H i g h l e v e l [ m ]
◄ 6 . 0 0
0
6 Level settings
For an easier access to the set the different levels there is a specific level settings menu where will set
the start and stop level for the pumps as well as low and high levels alarms.
7 Manual start and stop of pumps
When the pumps are in Auto mode they can be started manually from the PC 200, this is the menu
where you can start and stop pumps manually.
You will be able to start and stop all used pumps, if they don’t have any active condition that prevents
them from starting, alarms low level etc.
M a n u a l c o n t r o l ►
▼▲
▼▲
L e v e l s e t t i n g s ►
▼▲
▼▲
▼▲
▼▲
▼▲
▼▲
▼▲
The pumps can only be started if the actual level is between
the start and stop level settings.
The pumps are started and stopped by pressing the OK key.
Here you set the start och stop levels for the pumps and the
level for low and high alarm