Drip Drop PC-200 - 5.6.2 Trusted login; 5.6.3 Operator password; 5.6.4 System password; 5.6.5 Clock setting

MANUAL PC-200
Ver. 2.12.xx/10/22/2010-UK
Page 39 (61)
S y s . p a s s w o r d
◄ 0 0 0 0
0
C l o c k s e t t i n g ►
◄
0
C l o c k s e t t i n g
1 1 / 0 5 1 2 : 5 7 : 1 1
0
D e f a u l t s e t t i n g s
A r e y o u s u r e ?
0
D e f a u l t s e t t i n g s ►
◄
0
5.6.2 Trusted login
You have the option to set the unit to work with different log-in modes. The default factory setting is
that you need to log in whenever a change is made or an alarm is confirmed.
However, if preferred the unit can be set to always be logged-in for system privileges or to always be
logged-in for operator privileges.
5.6.3 Operator password
To change the passwords you use a combination of the four arrow keys .
5.6.4 System password
5.6.5 Clock setting
5.6.6 Default settings
Resets the controller to normally used pumpstation applications,
The prompt “Are you sure” is shown and must be confirmed with the OK key.
T r u s t e d l o g i n
◄ s y s t e m
O p p a s s w o r d
◄ Z Z Z Z
▼▲
▼▲
▼▲
▼▲
This menu is shown only if you are logged in with system code.
Choice between system, operator or none
To change to default settings press OK key
To change the system code press OK key and the cursor will be placed on the first
position which shall be changed, set new value, press OK to confirm. The cursor
moves to next position ▼▼▼▼
To change the clock setting press the OK key and the
cursor will be placed on the first position to be set. Set
value and press OK to confirm.The cursor is moved to next
position.
▼▲
To change the system code press OK key and the cursor will be placed on the first
position which shall be changed, set new value, press OK to confirm. The cursor
moves to next position.▲▲▲▲