Ducati Hyperstrada - Adjusting the Position of the Gearchange and Rear Brake Pedals

Adjusting the position of the gearchange
and rear brake pedals
The position of the gearchange and rear brake pedals
in relation to the footrests can be adjusted to suit the
requirements of the rider.
Adjust the pedals as follows:
Gear change pedal
Use an open ended spanner to hold the spherical end
on the rod (1) on the flat (2) and loosen the counter
nut (3).
Turn the screw (4) to detach the rod completely from
the gear change lever.
Turn the rod (5), until the gear change pedal is set to
the desired position.
Tighten the screw (4) to secure the gearchange lever
to the rod (5).
Tighten the lock nut (3) onto the ball joint (1).
1 2 3 5 4
Fig. 85
136