ABS set up
This function allows customising ABS (Antilock
Braking System) intervention level and, if necessary,
disabling it. To display this function, access the
Setting Menu and select the R.MODE page.
Use buttons (1) and (2) to select the riding mode you
wish to edit, then press button (4). Use keys (1) and
(2) to select the ABS indicator, then press button (4)
to access the setup page. Now, always using buttons
(1) and (2), you can increase or decrease ABS level;
press button (4) to confirm the new level.
The different settings are 01, 02 and OFF.
Note
If OFF is set, the ABS will be disabled and the
corresponding ABS warning light will start flashing.
Once the new setup is selected, press button (4). The
instrument panel will automatically highlight the
"MEMORY" indicator; to store the new setup, keep
button (4) pressed for 3 seconds;
After this time, the instrument panel will display the
"MEMORIZED" indicator for 2 seconds as a
confirmation of the change made. The "EXIT" indicator
will be automatically highlighted; press button (4) to
quit this page and go back to the setting menu.
Note
If ABS OFF is selected and stored, Ducati
recommends paying the utmost attention while
riding and braking your bike.
Note
If on DEFAULT lettering right side a symbol is
displayed, this means that the default setup is active,
namely that the parameters shown are those set up
by Ducati.
71
To Next Page
Loading...
Need help?
General
