Ducati Hyperstrada User Manual

ENGINE set up
This function allows customising ENGINE power and
output.
To display this function, access the Setting Menu and
select the "R.MODE" page. Use buttons (1) and (2) to
select the riding mode you wish to edit, then press
button (4).
Use buttons (1) and (2) to select the "ENGINE"
indicator, then press button (4) to access the setup
page.
Now, always using buttons (1) and (2), you can
increase or decrease ENGINE level; press button (4)
to confirm the new level.
The different settings are HIGH, MEDIUM and LOW.
Once the new setup is selected, press button (4). The
instrument panel will automatically highlight the
"MEMORY" indicator; to store the new setup, keep
button (4) pressed for 3 seconds.
After this time, the instrument panel will display the
"MEMORIZED" indicator for 2 seconds as a
confirmation of the change made. The "EXIT" indicator
will be automatically highlighted; press button (4) to
quit this page and go back to the setting menu.
Note
If on DEFAULT lettering right side a symbol is
displayed, this means that the default setup is active,
namely that the parameters shown are those set up
by Ducati.
75

Ducati Hyperstrada Specifications

General

Transmission	6-speed
Frame	Tubular steel Trellis frame
Exhaust	2-1-2 system with catalytic converter and 2 lambda probes
Front Suspension	43 mm upside-down forks
Rear Suspension	Progressive linkage with adjustable Sachs monoshock
Front Brake	2 x 320 mm semi-floating discs, radially mounted Brembo monobloc 4-piston calipers
Rear Brake	245 mm disc, 2-piston caliper
Fuel Tank Capacity	16 liters (4.2 US gal)
Fuel Injection	Electronic fuel injection, 53 mm throttle bodies