Menu 1 functions: Trip meter (TRIP 1)
This function shows the partial distance travelled (km
or miles, based on the specific application).
Holding button (1) pressed for 3 seconds when this
function is displayed resets the trip meter. When the
reading exceeds 9999.9, distance travelled is reset
and the meter automatically starts counting from 0
again. If the system measurement units are changed
at any moment, or if there is an interruption in the
power supply (Battery Off), the distance travelled is
reset and the count starts from zero (considering the
newly set unit of measurement).
Note
When this reading is reset, also "Average
Consumption", "Average Speed" and "Trip Time"
functions are reset.
To Next Page
Loading...
