Lap time function (LAP): LAP activation/
deactivation
This function activates and deactivates the LAP
function (lap time).
To display this function, access the Setting Menu and
select the "LAP" page.
The information will be displayed as follows:
- the tick (V) indicates that the setting is currently
enabled;
- use buttons (1) and (2) to highlight the new
setting;
- to store the new setting, press button (4); the tick
(V) will move on the stored condition.
To quit this page, select the "EXIT" wording, and press
button (4). Storing the "OFF" condition disables the
LAP function.
Storing the "ON" condition enables the LAP function.
Note
When the LAP function is enabled, button (3)
can be used both as high beam Flash and lap time
Start/Stop.
83
To Next Page
Loading...
Need help?
General
