Clock setting function (CLOCK)
This function allows setting the clock. To display this
function, access the Setting Menu and select the
"CLOCK" page. To access the setting page, keep
button (4) pressed for 3 seconds. After this time, the
"SETTING..." indicator will be enabled to confirm that
the setting page is active.
On entering this mode, the message “AM” will flash;
- press button (2): PM will start flashing;
- if you press button (2), the mode will go back to
previous setting (if it is 00:00, when toggling from
AM to PM, 12:00 will be displayed).
Pressing button (4) gives access to the hour setting
mode; hours start to flash;
- each time you press button (2), the count will
increase cyclically in steps of one hour;
- if button (2) is held pressed, the count will
increase cyclically in steps of one hour every
second (when the button is held depressed, the
hours do not flash).
Pressing button (4) gives access to the minutes
setting mode; minutes start to flash;
- each time you press button (2), the count will
increase cyclically in steps of one minute;
- if you hold button (2) pressed, the count will
increase cyclically in steps of 1 minute every
second.
- If button (2) is held depressed for over 5 seconds,
minutes will increase by 1 minute every 100 ms
(while button (2) is held depressed, seconds will
not flash).
To confirm (store) the new time setting, press button
(4). The "EXIT" indicator will be automatically
highlighted; press button (4) to quit this page and go
back to the setting menu.
Note
In case of battery off, when the Voltage is
restored and upon next Key-On, clock will have to be
set again (it will automatically start counting from
00:00).
91
To Next Page
Loading...
Need help?
General
