Answering the Highest Priority System Call-In
To answer the highest priority call-in follow the steps below.
1. ATEL: Lift the handset or press SPKR PHONE.
STEL, DTMF telephone, or CTEL: Lift the handset.
2. ATEL: Dial 745#, or press the function key programmed to dial that sequence. You are
automatically connected to the first highest priority call-in, regardless of the call’s
origin or programmed destination.
STEL, DTMF telephone, or CTEL: Dial 745#. You are automatically connected to
the first highest priority call-in, regardless of the call’s origin or programmed
destination.
3. ATEL: Speak clearly into the handset. Your voice triggers the talk mode to the calling
room. If you are using the speaker/microphone, press TALK and speak into the
microphone.
STEL, DTMF telephone, or CTEL: Speak clearly into the handset.
4. ATEL: Stop speaking into the handset or release the TALK key to listen for the reply
from the calling room.
STEL, DTMF telephone, or CTEL: Stop speaking to listen for the reply from the
calling room.
5. ATEL ONLY (handset): Pressing the MUTE button (F6 factory default) will
alternately mute and unmute both the talk and listen operation of the handset.
6. ATEL ONLY (push to talk): Press the VOL up/down key to adjust the listen volume.
Note:
The MUTE function is not available in this mode of operation.
7. ATEL: Hang up the handset or press SPKR PHONE to end the call. Failure to
replace the handset in the cradle will cause the ATEL to switch to an on-hook mode
of operation after a preset duration. If the ATEL converts to an on-hook mode, it still
rings as if the handset is in the cradle, therefore no calls are missed.
STEL, DTMF telephone, or CTEL: Hang up the handset to end the call.
Note:
The handset must be on-hook for a minimum of two seconds to end the call.
SCR+ Telephone Operation Manual
29
Answering Speaker Station Calls
To Next Page
Loading...