Message Waiting Indicator
Manually Setting the Message Waiting Indicator
The call assurance LED in a room can flash to act as a message waiting indicator. This
flash pattern (three rapid flashes, three seconds off) shows a message is waiting to be re
-
trieved by calling some predetermined extension. The Message Waiting Indicator feature
requires the optional Model 437-00127 Call Management Feature Package 1.
1. ATEL: Lift the handset or press SPKR PHONE.
STEL, DTMF telephone, or CTEL: Lift the handset.
2. ATEL: To activate the message indicator in a room, dial 7601, followed by the room
number and the # key.
STEL, DTMF telephone, or CTEL: Same as ATEL.
3. ATEL: To deactivate the message waiting indicator in a room, dial 7600, followed
by the room number and the # key.
Note:
After the message is received, the indicator must be deactivated, either by the person
receiving the message or by the person delivering the message, using step 3 above.
STEL, DTMF telephone, or CTEL: Same as ATEL.
Automatic Message Waiting Indicator Operation
(Fusion feature set only)
The message indicator for an extension (the call assurance LED) will flash when a new
voice mail message for that extension is received. If this extension is connected to a
CTEL equipped with a voice mail indicator, that indicator will also be activated when a
new voice mail message is received for that extension.
SCR+ Telephone Operation Manual
47
Message Waiting Indicator
To Next Page
Loading...