Dukane SCR+ - Calling an Outside Line Connected Via a PBX

Calling an Outside Line Connected via a PBX
For STARCall, STARCall Plus and STARCall Fusion systems connected to outside lines
through a PBX from another manufacturer.
1. ATEL: Lift the handset for a private conversation or press SPKR PHONE for
speaker/microphone conversation.
STEL, DTMF telephone, or CTEL: Lift the handset.
2. Dial 9 to connect to the PBX (may also be any number 80 through 89).
3. When the dial tone is heard, dial 9 again to access an outside telephone line through
the PBX.
Note:
The System may automatically dial the second 9 for outside line access.
4. If this is a toll call and a double tone burst is heard, enter a four-digit account
number.
5. After hearing the called party answer, speak normally into the handset or toward the
microphone.
6. ATEL ONLY: Stop speaking to listen for a reply.
7. ATEL ONLY: Pressing the MUTE function (F6 factory default) will alternately mute
and unmute both the transmitter and receiver in handset operation, or mute and
unmute the panel microphone in speaker/microphone operation.
8. ATEL ONLY: If push-to-talk speaker/microphone operation is desired, press and
release TALK to manually control the audio direction. The MUTE function is not
available in this mode.
9. ATEL ONLY: If you are using the speaker/microphone, you can adjust the speaker
listen volume by pressing the VOL up/down key.
10. ATEL: Hang up the handset or press SPKR PHONE to end the call. Failure to
replace the handset in the cradle will cause the ATEL to switch to an on-hook mode
of operation after a preset time. When in the on-hook mode, the ATEL will ring as if
the handset is in the cradle to prevent missing any calls.
STEL, DTMF telephone, or CTEL: Hang up the handset to end the call.
Note:
The handset must be on-hook for a minimum of two seconds to end the call.
36 SCR+ Telephone Operation Manual
Calling a Telephone