Dukane SCR+ - Line Pick-Up (Fusion Feature Set Only); Outside Line Call Park (Fusion Feature Set Only)

Outside Line Call Park (Fusion feature set only)
You can park a call by first placing the call on hold (see Placing a Call on Hold on the
preceding page) and dialing 763#. Your extension is now free to perform other opera
-
tions. A parked call can be picked up from any extension using the Line Pick-Up feature
(see below).
Note:
If the parked call is not picked up within a programmed time, the call rings back to the
extension which originally parked the call.
Line Pick-Up (Fusion feature set only)
This feature lets you access a specific outside line under certain conditions.
To use this feature from a System telephone lift the handset or go into speakerphone
mode and dial 79XX (where XX is the desired outside line number 01 – 32).
The table below lists the results when an outside line is selected under various conditions.
Line State Results
Idle Telephone receives dial tone and line can be used
for outbound dialing.
Ringing Outside line is connected to the telephone and
conversation can begin.
Parked Outside line is connected to the telephone and
conversation can begin.
On Hold Outside line is connected to the telephone and
conversation can begin.
Camped onto extension Outside line is connected to the telephone and
conversation can begin.
Waiting for Attendant or
DIL extension
Outside line is connected to the telephone and
conversation can begin.
Talking to another telephone Telephone receives reorder tone. Outside line
cannot be used if in active conversation.
If the trunk is equipped with the optional Caller ID module and enabled to receive
Caller ID, ATEL displays are updated with outside line number and caller’s caller ID in
-
formation.
40 SCR+ Telephone Operation Manual
Outside Line Call Park (Fusion feature set only)