Dukane SCR+ - Distributing an Audio Program to All but Excluded Zones

3. ATEL: Enter the audio program source (01 or 02), then the zone numbers (01–32),
and press #.
STEL, DTMF telephone, or CTEL: Same as ATEL.
Notes:
•
If only one audio program source is available, 01 will be the only source you can
select.
•
Zones 1 through 9 must be preceded by a 0 (entered as 01 through 09).
•
A double tone burst after pressing # indicates restricted access to this feature from
this phone. Enter a four-digit password after the tone to complete this operation.
See Password Control on page 3.
4. ATEL: The audio program continues until you cancel it (see Canceling Audio
Program Distribution, page 65).
STEL, DTMF telephone, or CTEL: Same as ATEL.
5. ATEL: Hang up the handset or press SPKR PHONE.
STEL, DTMF telephone, or CTEL: Hang up the handset.
Distributing an Audio Program to All But Excluded Zones
To distribute an audio program to all zones excluding those selected, follow the
steps below. Even if your System is networked, you can only distribute audio programs in
your own System.
1. ATEL: Lift the handset or press SPKR PHONE.
STEL, DTMF telephone, or CTEL: Lift the handset.
2. ATEL: Press PROGRAM then press 2, or dial 732.
STEL, DTMF telephone, or CTEL: Dial 732.
3. ATEL: Select the audio program source (01 or 02), then enter the zone numbers
(01–32) to be excluded, and press #.
STEL, DTMF telephone, or CTEL: Same as ATEL.
Notes:
•
If only one audio program source is available, 01 will be the only source you
can select.
•
Zones 1 through 9 must be preceded by a 0 (entered as 01 through 09).
•
A double tone burst after pressing # indicates restricted access to this feature from
this phone. You must enter a four-digit password after the tone to complete this
operation. See Password Control on page 3.
continued
SCR+ Telephone Operation Manual 61
Distributing Audio Programs