Dukane SCR+ - Distributing Tones to All but Excluded Rooms; Canceling Tone Distribution

Distributing Tones to All But Excluded Rooms
To distribute a tone to all rooms excluding those selected, follow the steps below. Even if
your System is networked, you can only distribute tones in your own System.
1. ATEL: Lift the handset or press SPKR PHONE.
STEL, DTMF telephone, or CTEL: Lift the handset.
2. ATEL: Press TONE then press 4, or dial 714.
STEL, DTMF telephone, or CTEL: Dial 714.
3. ATEL: Enter the tone number (01–26) (see Table 1 on page 56), then the room
numbers to be excluded, and press #.
STEL, DTMF telephone, or CTEL: Same as ATEL.
Notes:
Tones 1 through 9 must be preceded by a 0 (entered as 01 through 09).
A double tone burst after pressing # indicates restricted access to this feature from
this phone. You must enter a four-digit password after the tone to complete this
operation. See Password Control on page 3.
4. ATEL: The selected tone sounds until you cancel it (see Canceling Tone Distribution,
page 59), or until the tone duration expires.
STEL, DTMF telephone, or CTEL: Same as ATEL.
5. ATEL: Hang up the handset or press SPKR PHONE.
STEL, DTMF telephone, or CTEL: Hang up the handset.
Canceling Tone Distribution
This operation cancels a tone currently being distributed, whether it has been
programmed with a fixed or continuous duration.
1. ATEL: Lift the handset or press SPKR PHONE.
STEL, DTMF telephone, or CTEL: Lift the handset.
2. ATEL: Press TONE then press 5, or dial 715#.
STEL, DTMF telephone, or CTEL: Dial 715#.
3. ATEL: Hang up the handset or press SPKR PHONE.
STEL, DTMF telephone, or CTEL: Hang up the handset.
SCR+ Telephone Operation Manual 59
Distributing Tones