Dukane SCR+ - Removing Rooms from Audio Program Distribution in Progress

3. ATEL: Enter the audio program source (01 or 02), then the room numbers, and press #.
STEL, DTMF telephone, or CTEL: Same as ATEL.
Notes:
•
If only one audio program source is available, 01 will be the only source you
can select.
•
A double tone burst after pressing # indicates restricted access to this feature from
this phone. You must enter a four-digit password after the tone to complete this
operation. See Password Control on page 3.
•
To add only the speaker associated with the ATEL you are calling from, do not
enter a room number.
4. ATEL: Hang up the handset or press SPKR PHONE.
STEL, DTMF telephone, or CTEL: Hang up the handset.
Removing Rooms from Audio Program Distribution in Progress
To remove rooms from an audio program currently being distributed, follow the
steps below. Even if your System is networked, you can only distribute audio programs in
your own System.
1. ATEL: Lift the handset or press SPKR PHONE.
STEL, DTMF telephone, or CTEL: Lift the handset.
2. ATEL: Press PROGRAM then press 6, or dial 736.
STEL, DTMF telephone, or CTEL: Dial 736.
3. ATEL: Enter the room numbers, and press #.
STEL, DTMF telephone, or CTEL: Same as ATEL.
Notes:
•
A double tone burst after pressing # indicates restricted access to this feature from
this phone. You must enter a four-digit password after the tone to complete this
operation. See Password Control on page 3.
•
To remove only the speaker associated with the phone you are calling from, do not
enter a room number.
4. ATEL: Hang up the handset or press SPKR PHONE.
STEL, DTMF telephone, or CTEL: Hang up the handset.
64 SCR+ Telephone Operation Manual
Distributing Audio Programs