Dukane SCR+ - Setting the Date; Setting the Time of Day

Setting the Time of Day
To set the time of day at your phone or local System, follow the steps below. If your
System has been networked to other Systems using a NIC, the time you set will only be
valid until a new time is set in the primary System, or until 2:58 a.m., when the primary
System updates all secondary Systems.
1. ATEL: Lift the handset or press SPKR PHONE.
STEL, DTMF telephone, or CTEL: Lift the handset.
2. ATEL: Dial 750 and enter the time:
a. For 24-hour format enter the four-digit time (e.g., 1355 for 1:55 p.m.) and press
#.
b. For 12-hour format enter the four-digit time (e.g., 0955 for 9:55 a.m.), press 0
for a.m. or 1 for p.m., and press #.
STEL, DTMF telephone, or CTEL: Same as ATEL.
Note:
A double tone burst after pressing # indicates restricted access to this feature.
You must enter a four-digit password after the tone to complete this operation. See
Password Control on page 3.
3. ATEL: Hang up the handset or press SPKR PHONE.
STEL, DTMF telephone, or CTEL: Hang up the handset.
Setting the Date
To set the correct date for your phone or local System, follow the steps below. If your
System has been networked to other Systems using a NIC, the date you set will only be
valid until a new date is set in the primary System, or until 2:58 a.m., when the primary
System updates all secondary Systems.
1. ATEL: Lift the handset or press SPKR PHONE.
STEL, DTMF telephone, or CTEL: Lift the handset.
68 SCR+ Telephone Operation Manual
Setting the Time of Day