Paging All But Excluded Zones
To make a zone page that excludes selected zones, follow the steps below. If your System
has been networked to other Systems using a NIC, you can page zones in all networked
Systems. If your System has not been networked, you can only page zones in your own
System.
1. ATEL: Lift the handset or press SPKR PHONE.
STEL, DTMF telephone, and CTEL: Lift the handset.
2. ATEL: Press PAGE then press 2, or dial 722.
STEL, DTMF telephone, and CTEL: Dial 722.
3. ATEL: Enter the zone numbers (01–32) to be excluded and press #.
STEL, DTMF telephone, and CTEL: Same as ATEL.
Notes:
•
Zones 1 through 9 must be preceded by a 0 (entered as 01 through 09).
•
In networked Systems, only speakers assigned to zones 17 through 32 can receive
pages from other Systems in a network. Speakers assigned to zones 1 through 16
CANNOT receive any pages from other Systems in a network. All 32 zones in a
local System receive pages originating in their own system.
•
A double tone burst after pressing # indicates restricted access to this feature from
this phone. You must enter a four-digit password after the tone to complete this
operation. See Password Control on page 3.
4. ATEL: Speak clearly into the handset or microphone to make a page announcement.
STEL, DTMF telephone, and CTEL: Speak clearly into the handset to make a page
announcement.
5. ATEL ONLY: If muting is also desired while using the microphone, press TALK to
change from hands-free to push-to-talk paging. Thereafter, pushing TALK allows
page audio through, while releasing TALK mutes the microphone. The MUTE
button can also be used to toggle between mute and unmute.
6. ATEL: Hang up the handset or press SPKR PHONE to end the page.
STEL, DTMF telephone, and CTEL: Hang up the handset to end the page.
SCR+ Telephone Operation Manual
53
Paging
To Next Page
Loading...