3. ATEL: Enter the tone number (01–26) (see Table 1 on page 56), then enter the zone
numbers (01–32) to be excluded, and press #.
STEL, DTMF telephone, or CTEL: Same as ATEL.
Notes:
•
Tones 1 through 9 must be preceded by a 0 (entered as 01 through 09).
•
Zones 1 through 9 must be preceded by a 0 (entered as 01 through 09).
•
A double tone burst after pressing # indicates restricted access to this feature
from this phone. You must enter a four-digit password after the tone to complete
this operation. See Password Control on page 3.
4. ATEL: The selected tone sounds until you cancel it (see Canceling Tone Distribution,
page 59), or until the tone duration expires.
STEL, DTMF telephone, or CTEL: Same as ATEL.
5. ATEL: Hang up the handset or press SPKR PHONE.
STEL, DTMF telephone, or CTEL: Hang up the handset.
Distributing Tones to Selected Rooms
To distribute a tone to selected rooms, follow the steps below. Even if your System is net-
worked, you can only distribute tones in your own System.
1. ATEL: Lift the handset or press SPKR PHONE.
STEL, DTMF telephone, or CTEL: Lift the handset.
2. ATEL: Press TONE then press 3, or dial 713.
STEL, DTMF telephone, or CTEL: Dial 713.
3. ATEL: Enter the tone number (01–26) (see Table 1 on page 56), then the room
numbers, and press #.
STEL, DTMF telephone, or CTEL: Same as ATEL.
Notes:
•
Tones 1 through 9 must be preceded by a 0 (entered as 01 through 09).
•
A double tone burst after pressing # indicates restricted access to this feature
from this phone. You must enter a four-digit password after the tone to complete
this operation. See Password Control on page 3.
4. ATEL: The selected tone sounds until you cancel it (see Canceling Tone Distribution,
page 59), or until the tone duration expires.
STEL, DTMF telephone, or CTEL: Same as ATEL.
5. ATEL: Hang up the handset or press SPKR PHONE.
STEL, DTMF telephone, or CTEL: Hang up the handset.
58
SCR+ Telephone Operation Manual
Distributing Tones
To Next Page
Loading...