Busy Station Intercom (Fusion feature set only)
If a called extension is busy, you can transfer the call to a room speaker associated with
that extension by pressing 2 while the busy signal sounds. You can then communicate
with the room without interrupting the telephone conversation in progress.
Note:
The extension trying to initiate busy station intercom cannot have a call on hold at
the time or busy station intercom will not be enabled.
Call Back (Fusion feature set only)
If a called extension is busy, you can request call back by pressing 1 while the busy sig
-
nal sounds. When the called extension is free, the System rings the originating extension.
When the originating extension picks up, a call is automatically placed to the requested
extension.
Note:
If the originating extension is busy when the call back occurs, the call back will not
be completed.
Calling a PBX/KSU Telephone Extension
A PBX/KSU extension is a phone connected to a phone switch. Calling a PBX/KSU tele-
phone extension requires the optional Model 437-00127 Call Management Feature
Package 1. This function also requires proper setup of both the PBX/KSU and the
System. If this function does not work, contact your Dukane distributor.
1. ATEL: Lift the handset for a private conversation or press SPKR PHONE for
speaker/microphone conversation.
STEL, DTMF telephone, or CTEL: Lift the handset.
2. ATEL: Dial the PBX/KSU extension number.
—OR—
Dial the access code assigned to the PBX/KSU (e.g., 81), then dial the PBX/KSU
extension number when the dial tone is heard.
STEL, DTMF telephone, or CTEL: Same as ATEL.
3. ATEL: After hearing the called party answer, speak normally into the handset or
toward the microphone.
STEL, DTMF telephone, or CTEL: After hearing the called party answer, speak
normally into the handset.
4. ATEL ONLY: If you are using the speaker phone function, stop speaking to listen
for a reply from the other extension.
continued
SCR+ Telephone Operation Manual
33
Calling a Telephone
To Next Page
Loading...