Dukane SCR+ - Distributing an Audio Program to All but Excluded Rooms; Adding Rooms to Audio Program Distribution in Progress

Distributing an Audio Program to All But Excluded Rooms
To distribute audio programming to all rooms excluding those selected, follow the steps
below. Even if your System is networked, you can only distribute audio programs in your
own System.
1. ATEL: Lift the handset or press SPKR PHONE.
STEL, DTMF telephone, or CTEL: Lift the handset.
2. ATEL: Press PROGRAM then press 4, or dial 734.
STEL, DTMF telephone, or CTEL: Dial 734.
3. ATEL: Select the audio program source (01 or 02), then the room numbers to be
excluded, and press #.
STEL, DTMF telephone, or CTEL: Same as ATEL.
Notes:
•
If only one audio program source is available, 01 will be the only source you
can select.
•
A double tone burst after pressing # indicates restricted access to this feature from
this phone. You must enter a four-digit password after the tone to complete this
operation. See Password Control on page 3.
4. ATEL: The audio program continues until you cancel it (see Canceling Audio
Program Distribution, page 65).
STEL, DTMF telephone, or CTEL: Same as ATEL.
5. ATEL: Hang up the handset or press SPKR PHONE.
STEL, DTMF telephone, or CTEL: Hang up the handset.
Adding Rooms to Audio Program Distribution in Progress
To add rooms to an audio program currently being distributed, follow the steps below.
Even if your System is networked, you can only distribute audio programs in your own
System.
1. ATEL: Lift the handset or press SPKR PHONE.
STEL, DTMF telephone, or CTEL: Lift the handset.
2. ATEL: Press PROGRAM then press 5, or dial 735.
STEL, DTMF telephone, or CTEL: Dial 735.
continued
SCR+ Telephone Operation Manual 63
Distributing Audio Programs