Dungs MPA 5111 User Manual

63 … 68
62 … 68
Printed in Germany • Edition 02.14 • Nr. 254 722
15 Time diagram
MPA51xx
by means of an extended module General version Viessmann version Error Waiting for heat request Waiting for parameter record stick adjustment Idle state control: Fan/stepped motor Idle state control LDW (air pressure switch) Watchdog loading phase Startup phase: Fan/stepped motor Waiting for air pressure VPS A: Decision VPS A : Emptying the area between the valves VPS A: Test time V1 VPS A: Filling the area between the valves VPA A: Gas pressure detection VPS A: Test time V2 Pre-aeration A
Parameter
P40 P42 P43 P44 P45 P60
Time
0... 0... max. 3 min max. 2 min max. 2 min 3 s max. 2 min max. 30 s 0.1 s 1...3 s 1...240 s 1...3 s 0.1 s 1...240 s 0...1 h
State number
0 1 2 3 4 5 6 7 8 9 10 11 12 13 14
Safety chain
Watchdog
Alarm
Temperature controller
Additional valve *4
Y1 Y3
V1
Y2 Y1
V2
Y3 Y2
Ignition
Fan relay
PWM1 (fan)
*2a
*2b
PWM2 (for ex. analogue 0...10 V)
● *2a
*2b
PWM3 (for ex. analogue 4... 20 mA)
● *2a
*2b
Stepped motor
● *2a
*2b
Flame (ionisation)
LDW *1
GDW min.
GDW VPS *5
Parameter record stick active
●
Parameter VPS Startup
Parameter VPS Regular switch-o
*1) The monitoring of the LDW depends on
the operating mode set in P14.
*2) Analogue and fan capacities as well as fan
speed can be set by means of curves.
a) Special modulation point: OFF
b) Special modulation point: Pre-aeration A
c) Special modulation point: Pre-aeration B
d) Special modulation point: Ignition position
e) Special modulation point: STA
f) Special modulation point: Stabilisation A
g) Special modulation point: Stabilisation B
h) Parameter P67: Start modulation degree
Standard mode
i) Parameter P81: Regular switch-o: Power
during transition
j) Special modulation point: Post-aeration
*3) In the waiting program state, the rst wait-
ing time is 2 minutes, then 5 minutes, then 1
hour and afterwards a time period which can
be set by means of a parameter between 1
minute and 50 hours. If the set time period is
smaller than the rst three intervals, these are
also reduced. Another parameter indicates
whether a fault switch-o is allowed and, if
yes, how many restart attempts are to be
carried out until the automatic burner control

Dungs MPA 5111 Specifications

General

Brand	Dungs
Model	MPA 5111
Category	Control Unit
Language	English