Need help?Do you have a question about the dunphy TD and is the answer not in the manual?
General description, standards, working parameters, and fuel types.
Covers fuel tanks, filtration, pumps, pipe runs, connections, and pressure regulation.
Details burner construction, components, and general arrangement drawings for different models.
Instructions for mounting the burner onto the appliance and ensuring a gas-tight seal.
Covers mounting, connection, and gas supply requirements for Unibloc and Siemens valves.
Details on oil installations, pump connections, priming, and required standards.
Covers electrical connections, inverter setup, and ventilation requirements.
Explains adjustment of nose cones and notes on low NOx heads.
Details settings for high/low burners and various modulating burner setups.
Explains gas head and multipipe gas nozzle adjustments.
Explains High/Low Gas and High/Low Oil operation.
Describes Pneumatic and Electronic Modulating burner operation.
Details on oil nozzles, burner guns, and oil operating systems.
Details on various DH series fuel pumps and motors.
Explains the control panel display and key functions.
Describes the step-by-step start-up procedure.
Explains Normal/Local modes, modulation, and non-volatile lockouts.
Details the emergency stop mechanism and safety notes.
Lists and explains parameters for the Ratiotronic 6000.
Covers basic settings, gas heat input, pre-commissioning, and firing.
Explains how to check and adjust combustion values.
Details commissioning for burners with electronic controls.
Outlines routine and major maintenance tasks.
Instructions for removing and reassembling the combustion head and motor.
Covers common faults and their probable causes.
Covers diagrams for different gas/oil configurations and assemblies.
Details on the LFL1.333 control box, wiring, and flame detection.
Covers Unibloc valves, Siemens VGD valves, SKP actuators, VPS 504, Variotronic valve, and DH pumps.
To Next Page
General