27
6. OPERATING PROCEDURES
OFFSET Mode
• In this mode, the paper ejected onto the paper
receiving table will be stacked into one set as
shown in the figure.
STRAIGHT Mode
• The paper ejected on the paper receiving table will
not be sorted but stacked into one pile.
Note 1
In the SORT and NORMAL modes, “Err1” or “Err2”
will be displayed on the NO. OF SETS window if the
unit stops because there is no more paper or because of
problems such as no-feeding, multi-feeding, jams, etc.
For Err1, remove the last set. For Err2, remove the last
two sets. These removed sets will not be included in
the number displayed on the NO. OF SETS window.
• For the OFFSET mode, the first paper ejected
after operations are resumed will be sorted into
the proper pile according to the number of sets
removed.
6-3. OFFSET MODE AND STRAIGHT MODE
To Next Page
Loading...
Need help?
General
