32
Cause
• Paper have been multi-fed from the paper feed table.
Correction
• There is excessive paper in the set ejected onto the
paper receiving table or downstream processing
device. Remove sets for the number (1 or 2) next
to Err displayed on the NO. OF SETS window. It
will not be included in the number displayed on
the window.
• Loosen the paper. Stack the paper neatly with
their heads aligned. Press the START/STOP key.
The error lamp will go off and operations will start
again.
• If the error occurs again, turn the paper feed
pressure knob to the left (weak) or move the
separator pressure adjusting lever to the right
(raise the pressure).
7-5. WHEN THE PAPER FEED TABLE ERROR
LAMP BLINKS QUICKLY IN RED
Cause
• Normally when the PRESET key has been
pressed, and when the multi-feeding detection
function cannot work for the paper on the paper
feed table.
Correction
• Stop the multi-feeding detection function of the
table with such paper with dip switch B on the
control panel.
• Press the PRESET key and check the state.
• If it is normal, press the START/STOP key.
Operations will start.
7-4. WHEN THE PAPER FEED TABLE ERROR LAMP BLINKS IN RED
7. WHAT TO DO WHEN...
Cover
Dip Switches B
To Next Page
Loading...
Need help?
General
