29
6. OPERATING PROCEDURES
2 Checking the number of sets
specified and re-inputting the number
• To check the number of sets input and specified,
press the COLLATION MODE key. It will be
displayed on the NO. OF SETS window. When
the key is pressed again, the window will show
how many sets the paper are to be collated into,
and operations can be carried out.
• To re-input the number, press the CLEAR key.
The NO. OF SETS window will display -000.
Carry out steps
ó
to
ö
again.
• For details of stacking paper, refer to “5-5.
Stacking Paper for the INTERLEAVING Mode”
on page 17.
3 Pressing the COLLATION MODE Key
COLLATION
MODE key
Lon
Shor
<NORMAL, ALTERNATIVE Modes> <INTERLEAVING Mode>
MODE Key
MODE Key
M
O
D
E
K
e
y
SINGLE
ALTERNATIVE
Stand-by
starting
MODE KeK
MODE Key
123 Key or
MODE Kee
Input the
number of sett
Mode for
inputting the
number of setss
C
L
E
A
R
K
e
y
Check the number
of sets specifiee
MODE Key : COLLATION MODE key
: Press the key for less than 0.5 seconds.
: Press the key for more than 0.5 seconds.
Shor
Lon
Shor
Shor
Lon
To Next Page
Loading...
Need help?
General
